Trusted mini split installation for Highland properties. Same-day service available, transparent pricing, and a workmanship guarantee.
Adding comfort to spaces in your Highland, UT home that lack ductwork is straightforward with a professionally installed mini-split system from KIC Refrigeration. We size each indoor head independently, position units at optimal heights for air distribution, and configure multi-zone controls to deliver efficient heating and cooling with SEER ratings reaching 33 in select models.
Properties throughout Highland (pop. 22,030) face unique demands when it comes to mini split installation. Utah heating loads, cooling calculations, and the insulation levels and duct configurations found in Highland homes all influence the approach we take. KIC Refrigeration tailors every mini split installation project to the conditions your property actually faces — no generic solutions.
Choosing the right contractor for mini split installation in Highland, UT makes all the difference between efficient comfort and a system that short-cycles. KIC Refrigeration uses Manual J load calculations, installs to manufacturer specifications, and backs every project with a warranty. Call (866) 858-2961 to schedule your free assessment.
How our NATE-certified technicians deliver quality mini split installation results from start to finish.
We assess each room or zone you want to condition — measuring square footage, ceiling height, insulation quality, window exposure, and heat gain sources — to select the correct indoor unit capacity in BTU for each head and the right outdoor condenser to serve them all.
Our Highland crew mounts indoor heads at 7 to 8 feet on reinforced brackets, positions the outdoor condenser with minimum manufacturer clearance on all sides, drills penetrations through exterior walls with a core bit, and installs lineset covers for a clean appearance.
KIC Refrigeration connects mini-split linesets in Highland, UT with precision. We use calibrated flaring tools to produce consistent 45-degree flares, torque all connections with a manufacturer-specified wrench setting, evacuate the system to below 500 microns, hold the vacuum for a minimum of 30 minutes to confirm integrity, and then release the factory pre-charge.
We power up the system, verify each indoor unit responds to the remote and thermostat commands, check refrigerant pressures in cooling and heating modes, configure Wi-Fi control if equipped, and demonstrate all operating modes and settings to you.
Transparent answers about mini split installation from our certified technicians.
The cost of mini split installation in Highland depends on the scope of work, equipment involved, system accessibility, and whether parts or refrigerant are required. KIC Refrigeration provides free in-home evaluations with transparent, written pricing so you know exactly what to expect before any work begins. We never charge a diagnostic fee when you proceed with the recommended repair or service.
KIC Refrigeration stands behind all mini split installation work in Highland, UT with a comprehensive workmanship warranty. Equipment installations carry full manufacturer warranties — often 10 years on parts and limited lifetime on heat exchangers and compressors — which we register on your behalf. Ask about specific coverage details during your free evaluation.
Standard homeowners insurance in Highland typically does not cover mini split installation related to normal wear and aging. However, if HVAC damage resulted from a covered peril such as a lightning strike, fire, or fallen tree, your policy may apply. KIC Refrigeration provides detailed documentation to support any insurance claim and can work directly with your adjuster.
KIC Refrigeration technicians are NATE-certified, EPA 608 licensed, and fully insured to perform mini split installation in Utah. NATE certification is the HVAC industry's highest credential, requiring technicians to pass rigorous exams on installation, service, and system performance. Our crews undergo ongoing manufacturer training to stay current on the latest equipment and techniques.
Hear from property owners who chose us for their heating and cooling needs.
"Furnace tune-up was straightforward and the technician was friendly. Gave some tips on filter replacement schedules which was helpful."
"AC repair was fast and fairly priced. The compressor was failing and they had the part on the truck. Done in about ninety minutes."
"Mini split repair was done right the first time. The outdoor unit had a refrigerant leak and they found it, fixed it, and recharged the system same day."